LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Automatic Transmission System (UA80F) - Service Information (1 Of 2)) >> DIFFERENTIAL OIL SEAL (for LH Side) >> Replacement [12/2019 - 10/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of automatic transaxle fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly Refer to INITIALIZATION [12/2019 - 10/2022]
Front wheel alignment adjustment
  1. Perform "Reset Memory"
  2. Perform "Calibration".
  • VSC is disabled or malfunctions
  • DTCs are output
  • Slip indicator light illuminates
  • ABS warning light illuminates
 Refer to UTILITY [12/2019 - 11/2023]
scientia non olet · About LEMON Manuals