LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Hybrid Control System - Diagnostic Codes (1 Of 5)) >> Hybrid Control System >> DTC P0705-62: Transmission Range Sensor "A" Circuit (PRNDL Input) Signal Compare Failure [11/2023 - ] >> Description

DTC P0705-62: Transmission Range Sensor "A" Circuit (PRNDL Input) Signal Compare Failure [11/2023 - ]: Description

WARNING: This page is about a different car, the 2025 Toyota Highlander and 2024 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

The shift lever position sensor sends 7 different switch signals to the hybrid vehicle control ECU. The hybrid vehicle control ECU uses these signals to detect the shift lever position (P, R, N, D or S). The hybrid vehicle control ECU also uses this information to determine the intended direction of travel (forward or reverse).

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0705-62 Transmission Range Sensor "A" Circuit (PRNDL Input) Signal Compare Failure Shift sensor circuit malfunction (abnormal pattern)
A malfunction in the P, R, N, D or S circuit is detected based on the shift sensor input pattern.
(1 trip detection logic)
  • Wire harness or connector
  • Shift lever position sensor
  • Hybrid vehicle control ECU
Does not come on Master Warning:
Comes on
RELATED DATA LIST

DTC No. Data List
P0705-62
  • Shift Position
  • Shift Position Sensor (PNB)
  • Shift Position Sensor (PR)
  • Shift Position Sensor (DB1)
  • Shift Position Sensor (DB2)
  • Shift Position Sensor (N)
  • Shift Position Sensor (R)
  • Shift Position Sensor (P)