DTC P0195-11: Engine Oil Temperature Sensor Circuit Short to Ground [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING GTS (CHECK FOR SHORT IN WIRE HARNESS)
*1 Engine Oil Temperature Sensor *2 ECM - Disconnect the engine oil temperature sensor connector.
- According to the display on the GTS, read the Data List.
Powertrain > Engine > Data List
Tester Display Engine Oil Temperature Sensor OK
GTS Display Specified Condition Engine Oil Temperature Sensor -40°C (-40°F) Result
Proceed to OK NG
Result:
OK
REPLACE ENGINE OIL TEMPERATURE SENSOR. Refer to REMOVAL [10/2022 - ]
Result:
NG
See step 2
- CHECK HARNESS AND CONNECTOR (ENGINE OIL TEMPERATURE SENSOR - ECM)
- Disconnect the engine oil temperature sensor connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C80-1 (THEO) or C88-99 (THEO) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR