DTC P012F-62: Engine Coolant Temperature/Engine Oil Temperature Signal Compare Failure [10/2022 - ]: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P012F-62)
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P012F-62 is output A DTC P012F-62 and other DTCs are output B HINT:
If any DTCs other than P012F-62 are output, troubleshoot those DTCs first.
- Record the Freeze Frame Data.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 11/2023] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2023 - ]
Result:
A
See step 2
- Read the DTCs.
- CHECK FREEZE FRAME DATA (COOLANT TEMPERATURE AND INTAKE AIR TEMPERATURE)
- Using the GTS, read the values displayed in the Freeze Frame Data recorded in step 1.
Powertrain > Engine > DTC (P012F-62) > Freeze Frame Data
Tester Display Coolant Temperature Intake Air Temperature - Read the value displayed on the GTS.
Standard
GTS Display Specified Condition Difference between the Coolant Temperature and the Intake Air Temperature Within 15°C (27°F) HINT:
- When the engine is cold, the value of the engine coolant temperature, engine oil temperature and intake air temperature should be approximately the same.
- If the result is not as specified, check that there are no heat sources such as a block heater in the engine compartment.
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for outlet side).
Refer to INITIALIZATION [10/2022 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR OUTLET SIDE). Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]
Result:
OK
See step 3
- Using the GTS, read the values displayed in the Freeze Frame Data recorded in step 1.
- CHECK FREEZE FRAME DATA (ENGINE OIL TEMPERATURE SENSOR AND INTAKE AIR TEMPERATURE)
- Using the GTS, read the values displayed in the Freeze Frame Data recorded in step 1.
Powertrain > Engine > DTC (P012F-62) > Freeze Frame Data
Tester Display Engine Oil Temperature Sensor Intake Air Temperature - Read the value displayed on the GTS.
Standard
GTS Display Specified Condition Difference between the Engine Oil Temperature Sensor and the Intake Air Temperature Within 15°C (27°F) HINT:
When the engine is cold, the value of the engine coolant temperature, engine oil temperature and intake air temperature should be approximately the same.
Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]
Result:
NG
REPLACE ENGINE OIL TEMPERATURE SENSOR. Refer to REMOVAL [10/2022 - ]
- Using the GTS, read the values displayed in the Freeze Frame Data recorded in step 1.