Typical Enabling Conditions
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
P011A
| All of the following conditions are met | - |
| Time after key-off | 5 hours or more |
| ECM | Started by soak timer |
| Ignition switch | Off |
| Either of the following conditions is met | A or B |
| A. Engine coolant temperature sensor (for outlet side) | -10°C (14°F) or higher |
| B. Engine coolant temperature sensor (for cylinder head side) | -10°C (14°F) or higher |
| Battery voltage | Higher than 8 V |
| Engine coolant temperature sensor (for outlet side) fail (P0117, P0118) | Not detected |
| Engine coolant temperature sensor (for cylinder head side) fail (P2184, P2185) | Not detected |
| Soak timer fail (P2610) | Not detected |
P111A
| All of the following conditions are met | - |
| Arrive at after engine stop | 5 hours or more |
| ECM | Started by soak timer |
| Ignition switch | Off |
| Either of the following conditions is met | A or B |
| A. Engine coolant temperature sensor (for outlet side) | -10°C (14°F) or higher |
| B. Engine coolant temperature sensor (for water inlet housing side) | -10°C (14°F) or higher |
| Battery voltage | Higher than 8 V |
| Engine coolant temperature sensor (for outlet side) circuit fail (P0117, P0118) | Not detected |
| Engine coolant temperature sensor (for water inlet housing side) circuit fail (P01E5, P01E6) | Not detected |
| Soak timer fail (P2610) | Not detected |