DTC P011A-62: Engine Coolant Temperature Sensor 1/2 Signal Compare Failure; DTC P111A-62: Engine Coolant Temperature Sensor 1/3 Signal Compare Failure [10/2022 - ]: Procedure

1. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P011A-62 is output	A
   DTC P111A-62 is output	B
   DTC P011A-62 and P111A-62 are output	C

2. Record the Freeze Frame Data.

   HINT: 

   • When the engine is cold, the value of the engine coolant temperature sensor (for water inlet housing side), engine coolant temperature sensor (for cylinder head side) and engine coolant temperature sensor (for outlet side) should be approximately the same.
   • If only one of the sensors has deviating output values, this sensor may be malfunctioning.

Result: 

B 

See step  3

Result: 

C 

See step  4

Result: 

A 

See step  2

1. Replace the engine coolant temperature sensor (for cylinder head side).

   Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]

   HINT: 

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for cylinder head side).

   Refer to INITIALIZATION [10/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Replace the engine coolant temperature sensor (for water inlet housing side).

   Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]

   HINT: 

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for water inlet housing side).

   Refer to INITIALIZATION [10/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Replace the engine coolant temperature sensor (for outlet side).

   Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]

   HINT: 

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for outlet side).

   Refer to INITIALIZATION [10/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

2. Turn the ignition switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

1. Start the engine and fully warm up the engine with the air conditioning off until the electric cooling fan starts to operate.
2. Read the Data List, when the engine is fully warmed up.

   Powertrain > Engine > Data List 

   Tester Display
   Coolant Temperature Sensor1
   Coolant Temperature Sensor2
   Coolant Temperature Sensor3

   Standard

   GTS Display	Condition	Specified Condition
   Difference between Coolant Temperature Sensor1 and Coolant Temperature Sensor2	After fully warming up	Within 20°C (36°F)
   Difference between Coolant Temperature Sensor1 and Coolant Temperature Sensor3

   HINT: 

   The engine can be judged as fully warmed up after warming up the engine with the air conditioning off until the electric cooling fan starts to operate.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END