LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine Cooling System (T24A-FTS) - Service Information) >> Water Pump >> Installation [10/2022 - ] >> Procedure

Installation [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE WATER PUMP ASSEMBLY 

    Torque: 21 N.m (214 kgf/cm, 15 ft.lbf) 

  2. INSTALL GENERATOR ASSEMBLY 

    Refer to INSTALLATION [10/2022 - 11/2023] , or refer to INSTALLATION [11/2023 - ]

  3. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  4. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  5. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 85 [10/2022 - 11/2023] , or refer to PROCEDURE - Step 85 [11/2023 - ]

  6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 87 [10/2022 - 11/2023] , or refer to PROCEDURE - Step 87 [11/2023 - ]

  7. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 87 [10/2022 - 11/2023] , or refer to PROCEDURE - Step 87 [11/2023 - ]

scientia non olet · About LEMON Manuals