DTC P2182-2A: Engine Coolant Temperature Sensor 2 Signal Stuck In Range [10/2022 - ]: Procedure

1. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P2182-2A is output	A
   DTC P2182-2A and other DTCs are output	B

   HINT: 

   If any DTCs other than P2182-2A are output, troubleshoot those DTCs first.

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 11/2023]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2023 - ] 

Result: 

A 

See step  2

1. Inspect the engine coolant temperature sensor (for cylinder head side).

   Refer to INSPECTION [10/2022 - ]

   HINT: 

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for cylinder head side).

   Refer to INITIALIZATION [10/2022 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE). Refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

Result: 

OK 

See step  3

1. Compare Data List items "Coolant Temperature Sensor1" and "Coolant Temperature Sensor2" when the engine is warmed up from an engine coolant temperature below 60°C (140°F) to 60°C (140°F) or higher.

   Powertrain > Engine > Data List 

   Tester Display
   Coolant Temperature Sensor1
   Coolant Temperature Sensor2

   HINT: 

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for cylinder head side).

   Refer to INITIALIZATION [10/2022 - ]

   Result

   Result	Proceed to
   Both Coolant Temperature Sensor1 and Coolant Temperature Sensor2 rise	A
   Both Coolant Temperature Sensor1 and Coolant Temperature Sensor2 do not rise	B
   Coolant Temperature Sensor2 does not rise	C

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [10/2022 - ] 

Result: 

C 

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE). Refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

Result: 

B 

See step  4

1. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

2. Turn the ignition switch off.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. With the engine stopped, leave the vehicle as is for 5 hours or more.
2. Start the engine and warm it up until the engine coolant temperature reaches 60°C (140°F) or higher.
3. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P2182-2A is output	B
   DTC P2182-2A and other DTCs are output	C

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [10/2022 - ] 

Result: 

B 

REPLACE WATER CONTROL VALVE. Refer to  REMOVAL [10/2022 - ] 

Result: 

C 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 11/2023]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2023 - ]