DTC P060D-49: Internal Control Module Accelerator Pedal Position Performance Internal Electronic Failure [11/2023 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

CLEAR DTC

Clear the DTCs.
Powertrain > Engine > Clear DTCs

Turn the ignition switch off.

Result

Proceed to
NEXT

Result:

See step 2

READ OUTPUT DTC (DTC P060D-49)

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Wait 16 seconds or more.

Read the DTCs.

Powertrain > Engine > Trouble Codes

Result

Result	Proceed to
DTCs are not output	A
DTC P060D-49 is output	B

Result:

CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2022 - ]

Result:

REPLACE ECM. Refer to REMOVAL [11/2023 - ]