DTC P0607-47: Control Module Performance Bank 1 Watchdog/Safety MCU Failure; DTC P0607-87: Control Module Performance Bank 1 Missing Message [10/2022 - 11/2023]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
Result:
NEXT
See step 2
- READ OUTPUT DTC (DTC P0607-47 OR P0607-87)
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Turn the ignition switch to ON.
- Wait 1 second or more.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P0607-47 or P0607-87 is output B
Result:
A
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2022 - ]
Result:
B
REPLACE ECM. Refer to REMOVAL [10/2022 - 11/2023]