DTC P0460-2A: Fuel Level Sensor "A" Signal Stuck In Range [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INTERVIEW THE CUSTOMER
- Interview the customer for details about when they refuel the vehicle.
HINT:
When the fuel tank is full, if the vehicle is repeatedly driven a short distance and then refueled, the fuel sender gauge output value will not change. In this case, the ECM may judge that the fuel sender gauge is stuck and store DTC P0460-2A. If the vehicle was driven in this manner, as the DTC was stored due to a user action, clear the DTCs without performing troubleshooting and return the vehicle to the customer.
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Interview the customer for details about when they refuel the vehicle.
- INSPECT FUEL SENDER GAUGE ASSEMBLY
- Inspect the fuel sender gauge assembly.
Refer to INSPECTION [10/2022 - ]
Result
Proceed to OK NG
Result:
OK
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2022 - ]
Result:
NG
REPLACE FUEL SENDER GAUGE ASSEMBLY. Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]
- Inspect the fuel sender gauge assembly.