Typical Enabling Conditions
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
The stop light switch remains on during GO and STOP driving 5 times.
GO and STOP are defined as follows:
| The monitor will run whenever the following DTCs are not stored | None |
| GO (Vehicle speed is 30 km/h (18.65 mph) or more) | Once |
| STOP (Vehicle speed is less than 3 km/h (1.86 mph)) | Once |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |