Confirmation Driving Pattern
WARNING: This page is about a different car, the 2025 Toyota Highlander and 2024 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
After repair has been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Refer to UTILITY [11/2023 - ]
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the ignition switch off and wait for at least 30 seconds.
- Turn the ignition switch to ON (READY) and wait for 1 minute or more.
- Enter the following menus: Powertrain / Engine / Utility / All Readiness.
- Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE, perform driving pattern again.