LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Starting System (W/ Stop And Start System) (T24A-FTS) - Service Information) >> STARTER (w/ Stop And Start System) >> Installation [10/2022 - 11/2023] >> Procedure

Installation [10/2022 - 11/2023]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 

    Bolt 

    Torque: 46 N.m (469 kgf/cm, 34 ft.lbf) 

    Nut 

    Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

  2. INSTALL FLYWHEEL HOUSING SIDE COVER 
    1. GTY1105568Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.
        NOTE:
        • Make sure the claw makes a click sound, indicating that it fits tightly.
        • Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
  3. CONNECT ENGINE WIRE 
  4. INSTALL INTAKE MANIFOLD WITH INTERCOOLER ASSEMBLY 

    Refer to INSTALLATION [10/2022 - ]

  5. INSTALL AIR CLEANER HOSE ASSEMBLY 

    Refer to PROCEDURE - Step 52

  6. CONNECT NO. 2 VENTILATION HOSE 

    Refer to PROCEDURE - Step 53

  7. INSTALL AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 4

  8. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 5

  9. INSTALL COOL AIR INTAKE DUCT SEAL 
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

  11. ADD COOLANT (for Intercooler) 

    Refer to REPLACEMENT [10/2022 - ]

  12. ADD ENGINE COOLANT 

    Refer to REPLACEMENT [10/2022 - ]

scientia non olet · About LEMON Manuals