Installation [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE COVER BRACKET

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)

INSTALL NO. 3 WATER BY-PASS PIPE

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)

INSTALL NO. 1 TURBO PRESSURE SENSOR

NOTE:

If the No. 1 turbo pressure sensor has been struck or dropped, replace it.

Using an 8 mm socket wrench, remove the bolt and No. 1 turbo pressure sensor from the intake manifold
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)

INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to INSTALLATION [10/2022 - ]