LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Fuel System (T24A-FTS) - Service Information) >> Fuel Sender Gauge Assembly >> Installation [10/2022 - ] >> Procedure

Installation [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Engage the 2 claws to install the fuel sender gauge assembly to the fuel gauge bracket.
    2. Engage the 2 claws to install the fuel gauge bracket with fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
      NOTE:

      Be careful not to bend the arm of the fuel sender gauge assembly.

    3. Engage the 3 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.
      NOTE:
      • Do not damage the wire harness.
      • When engaging each wire harness to the clamp, engage one wire at a time.
    4. Connect the fuel sender gauge assembly connector.
  2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [10/2022 - 11/2023] , or refer to INSTALLATION [11/2023 - ] 

scientia non olet · About LEMON Manuals