LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Fuel System (T24A-FTS) - Service Information) >> Fuel Pump Ecu >> Installation [10/2022 - ] >> Procedure

Installation [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL PUMP CONTROL ECU BRACKET 
    1. Install the fuel pump control ECU bracket to the fuel pump control ECU with the 2 bolts.

      Torque: 4.5 N.m (46 kgf/cm, 40 in.lbf) 

  2. INSTALL FUEL PUMP CONTROL ECU 
    1. Install the fuel pump control ECU to the vehicle body with the 2 nuts.

      Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

      NOTE:

      Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.

    2. Connect the 2 fuel pump control ECU connectors.
  3. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (w/ Woofer) 

    Refer to PROCEDURE - Step 1

  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH 

    Refer to PROCEDURE - Step 21

  5. INSTALL ROPE HOOK 

    Refer to PROCEDURE - Step 22

  6. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK 

    Refer to PROCEDURE - Step 23

  7. INSTALL DECK TRIM POCKET COVER 

    Refer to PROCEDURE - Step 24

  8. INSTALL NO. 2 DECK SIDE TRIM COVER 

    Refer to PROCEDURE - Step 26

  9. INSTALL FRONT DECK SIDE TRIM COVER LH 

    Refer to PROCEDURE - Step 28

  10. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 1

  11. INSTALL REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 45

  12. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH 

    Refer to PROCEDURE - Step 46

  13. INSTALL REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 63

  14. INSTALL REAR NO. 2 SEAT ASSEMBLY 

    Refer to INSTALLATION [12/2019 - ]

scientia non olet · About LEMON Manuals