LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Fuel System (T24A-FTS) - Service Information) >> Fuel Pressure Sensor >> Installation [10/2022 - 11/2023] >> Procedure

Installation [10/2022 - 11/2023]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 2 FUEL PRESSURE SENSOR 
    1. GTY1181083Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 2 Fuel Pressure Sensor *2 No. 2 Fuel Pressure Sensor Holder
      *a Flat - -
      1. Install a new No. 2 fuel pressure sensor to the No. 2 fuel pressure sensor holder as shown in the illustration.
  2. INSTALL NO. 2 FUEL PRESSURE SENSOR HOLDER 
    1. GTY1105821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor holder to the fuel delivery pipe with the bolt.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      2. Connect the No. 2 fuel pressure sensor connector.
  3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 56

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

  5. INSPECT FOR FUEL LEAK 

    Refer to PROCEDURE - Step 1

  6. PERFORM INITIALIZATION 
    1. Perform "Inspection After Repair" after replacing a No. 2 fuel pressure sensor.

      Refer to INITIALIZATION [10/2022 - ]

scientia non olet · About LEMON Manuals