Removal [10/2022 - 11/2023]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Refer to REMOVAL [10/2022 - 11/2023]
- REMOVE FUEL PRESSURE REGULATOR HOLDER
- REMOVE FUEL MAIN VALVE ASSEMBLY
- Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.
*a Protective Tape NOTE:- Pull out the fuel main valve assembly carefully because the O-ring is firmly installed between the fuel main valve assembly and fuel suction tube with pump and gauge assembly.
- Do not damage the fuel suction tube with pump and gauge assembly.
- Remove the O-ring from the fuel main valve assembly.
*1 O-ring *a Mesh *b Mini-clip NOTE:Do not remove the mesh and mini-clip from the fuel main valve assembly.
- Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.