LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Control System (T24A-FTS) - Service Information) >> Manifold Absolute Pressure Sensor >> Inspection [10/2022 - ] >> Procedure

Inspection [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT NO. 1 TURBO PRESSURE SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY1078380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 1 Turbo Pressure Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      4 (THIM) - 2 (E2) - 20°C (- 4°F) 14.6 to 17.8 kΩ
      20°C (68°F) 2.21 to 2.69 kΩ
      80°C (176°F) 0.290 to 0.354 kΩ

      If the result is not as specified, replace the No. 1 turbo pressure sensor.

scientia non olet · About LEMON Manuals