Installation [10/2022 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Torque Wrench Fulcrum Length

   -

   -

   1. Install a new gasket to the engine oil temperature sensor.
   2. Using SST, install the engine oil temperature sensor to the cylinder block sub-assembly.
      • SST: 09817-33191 
      • SST: 09961-01270 

      Specified tightening torque 

      Torque: 19.6 N.m (200 kgf/cm, 14 ft.lbf) 

      NOTE:

      If the engine oil temperature sensor has been struck or dropped, replace it.

      HINT: 

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Refer to PRECAUTION [12/2019 - 11/2023] , or refer to PRECAUTION [11/2023 - ]

      • When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):

        8.8 N.m (90 kgf/cm, 78 in.lbf)

   3. Connect the engine oil temperature sensor connector.

Refer to PROCEDURE - Step 6

Refer to PROCEDURE - Step 1 [10/2022 - 11/2023] , or refer to PROCEDURE - Step 1 [11/2023 - ]