Removal [10/2022 - 11/2023]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE STARTER ASSEMBLY
- w/ Stop And Start System:
Refer to REMOVAL [10/2022 - 11/2023]
- w/o Stop And Start System
Refer to REMOVAL [10/2022 - 11/2023]
- w/ Stop And Start System:
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the crankshaft position sensor connector.
- Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.NOTE:
If the crankshaft position sensor has been struck or dropped, replace it.
- Perform this procedure only when reusing the crankshaft position sensor.
- Remove the O-ring from the crankshaft position sensor.
NOTE:- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
- If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.