LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Control System (T24A-FTS) - Service Information) >> Accelerator Pedal >> Installation [10/2022 - ] >> Procedure

Installation [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL 
    1. Engage the claw to install the accelerator pedal.
      GTY888079Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 bolts.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

  2. INSTALL ACCELERATOR PEDAL PAD 
    1. Engage the 4 claws to install the accelerator pedal pad to the accelerator pedal.
  3. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY 
    NOTE:
    • Avoid physical shock to the accelerator pedal sensor assembly.
    • Do not disassemble the accelerator pedal sensor assembly.
    • The accelerator pedal sensor assembly does not require lubrication.
    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
    1. Connect the rod of the accelerator pedal sensor assembly to the accelerator pedal and install the accelerator pedal sensor assembly with the 3 nuts.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

    2. Connect the accelerator pedal sensor assembly connector.
  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 28

  5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 49

  6. INSTALL FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 50

scientia non olet · About LEMON Manuals