LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Starting System (T24A-FTS) - Service Information) >> Engine Switch >> Removal [10/2022 - 11/2023] >> Procedure

Removal [10/2022 - 11/2023]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [10/2022 - ]

  2. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 9

  3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 10

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 4

  5. REMOVE INSTRUMENT PANEL FINISH END PANEL LH 

    Refer to PROCEDURE - Step 5

  6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 6

  7. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  8. REMOVE TRIP SWITCH 

    Refer to PROCEDURE - Step 5

  9. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 9

  10. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 17

  11. REMOVE NO. 1 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 20

  12. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22

  13. REMOVE RADIO AND DISPLAY ASSEMBLY WITH AIR CONDITIONING CONTROL 

    for 8 Inch Display:

    Refer to PROCEDURE - Step 3

    for 12.3 Inch Display:

    Refer to PROCEDURE - Step 9

  14. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 25

  15. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

  16. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  17. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH 

    Refer to PROCEDURE - Step 28

  18. REMOVE INSTRUMENT PANEL FINISH END PANEL RH 

    Refer to PROCEDURE - Step 29

  19. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 30

  20. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 31

  21. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 39

  22. REMOVE FRONT CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 41

  23. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT 

    Refer to PROCEDURE - Step 42

  24. REMOVE ENGINE SWITCH 
    1. Disengage the 2 claws and remove the engine switch.
      GTY888567Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals