Steering Pad Switch Circuit [10/2022 - ]: Procedure

Refer to INSPECTION [12/2019 - ]

Result

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

Result: 

OK 

See step  2

Refer to INSPECTION [12/2019 - ]

Result

Result: 

NG 

REPLACE SPIRAL CABLE SUB-ASSEMBLY. Refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

Result: 

OK 

See step  3

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H24-10 (+DP2) - Body ground	Ignition switch ON	4.8 to 5.2 V
   H24-11 (+DP) - Body ground	Ignition switch ON	4.8 to 5.2 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  5

Result: 

OK 

See step  4

1. Disconnect the H107 radio and display receiver assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H107-20 (SWG) - H24-4 (EAU)	Always	Below 1 Ω
   H107-1 (GND1) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

1. Disconnect the H113 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H24-10 (+DP2) - H113-29 (MSM+)	Always	Below 1 Ω
   H24-11 (+DP) - H113-12 (MSTI)	Always	Below 1 Ω
   H24-10 (+DP2) or H113-29 (MSM+) - Body ground	Always	10 kΩ or higher
   H24-11 (+DP) or H113-12 (MSTI) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2019 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR