DTC P0500-31: Vehicle Speed Sensor "A" No Signal [09/2022 - 11/2022]: Procedure

HINT: 

This procedure confirms whether the speedometer is operating correctly.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Data List / Vehicle Speed.

   Powertrain > Engine > Data List 

   Tester Display
   Vehicle Speed

5. Drive the vehicle.
6. Read the value displayed on the Techstream.

   Result

   Result	Proceed to
   Values displayed on Techstream and speedometer display not equal	A
   Values displayed on Techstream and speedometer display equal	B

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to CHECK FOR INTERMITTENT PROBLEMS [06/2018 - ]

Result: 

A 

See step  2

1. Check the circuits that send vehicle speed signals to this system in the combination meter system.

   for 12.3 Inch Display: Refer to Speed Signal Circuit [09/2022 - 11/2022]

   except 12.3 Inch Display: Refer to Speed Signal Circuit [09/2022 - 11/2022]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Disconnect the combination meter assembly connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance (for TMMMS Made)

   Tester Connection	Condition	Specified Condition
   I4-36 (+S) - A47-42 (SPD)	Always	Below 1 Ω

   Standard Resistance (for TMC Made)

   Tester Connection	Condition	Specified Condition
   I4-8 (+S) - A47-42 (SPD)	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM 

Refer to REMOVAL [09/2022 - 11/2022]

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR