Removal [06/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

Disconnect the cam timing oil control solenoid assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using an 8 mm socket wrench, remove the 2 bolts and cam timing oil control solenoid assembly from the No. 2 timing chain cover assembly.
NOTE:
If the cam timing oil control solenoid assembly has been struck or dropped, replace it.

REMOVE O-RING

HINT:

Perform this procedure only when replacement of the O-ring is necessary.

Remove the O-ring from the cam timing oil control solenoid assembly.

NOTE:

When removing the O-ring, be careful not to damage the O-ring groove of the cam timing oil control solenoid assembly.
If the O-ring groove of the cam timing oil control solenoid assembly is damaged, replace the cam timing oil control solenoid assembly with a new one.