Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during transmission wire removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Replacement of CVT fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly | Refer to INITIALIZATION [09/2022 - 11/2022] |
| Replacement of transmission valve body assembly |
|
|
Refer to INITIALIZATION [09/2022 - 11/2022]
for Initialization Refer to REGISTRATION [06/2018 - 09/2024] for Registration |
*: It is only necessary TMMMS Made Models