LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 77 (Automatic Transaxle System (K120 / K121) - Service Information (5 Of 5)) >> Transmission Wire >> Removal [03/2023 - 09/2024] >> Procedure

Removal [03/2023 - 09/2024]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TRANSMISSION VALVE BODY ASSEMBLY 
  2. REMOVE TRANSMISSION WIRE 
    1. Disengage the claw, rotate the lever and disconnect the transmission wire connector.
      GTY894722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Disconnect the transmission revolution sensor (NC1) connector.
      GTY809858Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and transmission wire from the transaxle case sub-assembly.
      GTY829411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the O-ring from the temperature sensor.
      GTY787480Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals