Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during transmission wire removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Replacement of CVT fluid	ATF thermal degradation estimate reset	The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly	for K120: Refer to INITIALIZATION [11/2022 - 09/2024] for K121: Refer to INITIALIZATION [03/2023 - ]
Replacement of transmission valve body assembly	for K120 Reset transaxle compensation code Perform reset memory CVT oil pressure calibration Perform road test to allow TCM to learn	Large shift shock Deterioration of fuel efficiency	Initialization: Refer to INITIALIZATION [11/2022 - 09/2024] Registration: Refer to REGISTRATION [06/2018 - 09/2024]
Replacement of transmission valve body assembly	for K121 Reset transaxle compensation code Perform reset memory CVT oil pressure calibration Perform road test to allow ECM to learn	Large shift shock Deterioration of fuel efficiency	Initialization: Refer to INITIALIZATION [03/2023 - ] Registration: Refer to REGISTRATION [03/2023 - ]