Inspection [06/2018 - 09/2022]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT COMBINATION SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 6 (MSW1) - 5 (E) Pressed Below 50 Ω Not pressed 10 kΩ or higher If the result is not as specified, replace the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly) - Apply battery voltage between the terminals of the switch and check the illumination condition of the combination switch assembly.
Standard
Measurement Condition Specified Condition Battery positive (+) → 4 (ILL+)
Battery negative (-) → 1 (ILL-)Illuminates If the result is not as specified, replace the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)
- Measure the resistance according to the value(s) in the table below.