Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during TCM removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [06/2018 - 09/2022] |
| Pre-collision System | |||
| Lighting System (w/ AFS) (EXT) | |||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [06/2018 - 09/2022] | |
| Replacement of TCM (If transaxle compensation code read from TCM) |
|
|
Refer to INITIALIZATION [06/2018 - 09/2022]
for Initialization Refer to REGISTRATION [06/2018 - 09/2024] for Registration |
| Replacement of TCM (If transaxle compensation code not read from TCM) |
|
*: Not necessary when TCM replaced with new one.
NOTE:
- After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System)
- After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)