LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 73 (Engine Intake System (M20A-FKS) - Inspection) >> Intake System >> On-Vehicle Inspection [09/2022 - ] >> Procedure

On-Vehicle Inspection [09/2022 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT INTAKE SYSTEM 
    WARNING:
    • When working near the engine room while the engine has started or the power source mode is engine switch on (IG), do not touch the fan and generator V belt or rotating components such as the fan, etc.
    • Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.
    GTY600652Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    HINT: 

    Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

    Refer to INITIALIZATION [04/2020 - 11/2022] , or refer to INITIALIZATION [11/2022 - ]

    1. Check that there are no vacuum leaks at the points shown in the illustration.
      GTY919251Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. PERFORM INITIALIZATION 
    1. Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

      Refer to INITIALIZATION [04/2020 - 11/2022] , or refer to INITIALIZATION [11/2022 - ]

scientia non olet · About LEMON Manuals