On-Vehicle Inspection [09/2022 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT FAN NO. 1 RELAY
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the FAN NO. 1 relay.
- Measure the resistance according to the value(s) in the table below.
- Check the resistance.