Removal [09/2019 - 09/2022]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 9 [09/2019 - 06/2021] , or refer to PROCEDURE - Step 9 [06/2021 - 09/2022]
- DRAIN ENGINE COOLANT (for Fully Sealed Type)
Refer to PROCEDURE - Step 1
- DRAIN ENGINE COOLANT (for Non-Fully Sealed Type)
Refer to PROCEDURE - Step 2
- REMOVE HEADLIGHT ASSEMBLY
Refer to REMOVAL [01/2019 - 09/2022]
- REMOVE INLET NO. 3 AIR CLEANER
- REMOVE INLET NO. 1 AIR CLEANER
- REMOVE INLET NO. 2 AIR CLEANER
- REMOVE HOOD LOCK ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
- Disengage the clamp to disconnect the hood lock control cable assembly from the upper radiator support sub-assembly.
- Disconnect the horn connector.
- Disengage the 3 clamps to disconnect the wire harness from the upper radiator support sub-assembly.
- Remove the 5 bolts and upper radiator support sub-assembly.
- Disengage the clamp to disconnect the hood lock control cable assembly from the upper radiator support sub-assembly.
- DISCONNECT NO. 2 WATER BY-PASS HOSE (for Fully Sealed Type)
- DISCONNECT NO. 1 RADIATOR HOSE
- DISCONNECT NO. 2 RADIATOR HOSE
- REMOVE NO. 2 RADIATOR AIR GUIDE
- REMOVE FAN WITH MOTOR ASSEMBLY
- Disconnect the cooling fan motor connector.
*a Lock Lever - Disengage the claw and raise the lock lever to disconnect the cooling fan motor connector as shown in the illustration.NOTE:
After disconnecting the cooling fan motor connector, make sure that dirt, water or other foreign matter does not contact the connecting parts of the cooling fan motor connector.
- Disengage the claw and raise the lock lever to disconnect the cooling fan motor connector as shown in the illustration.
- Disengage the 2 wire harness clamps.
- Disengage the 2 claws.
- Disengage the 2 guides to remove the fan with motor assembly from the radiator assembly.NOTE:
Do not damage the radiator assembly when removing the fan with motor assembly.
- Disconnect the cooling fan motor connector.
- REMOVE FAN
- REMOVE COOLING FAN MOTOR