DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [03/2019 - ]: Procedure

1. Replace the cam timing control motor with EDU assembly.

   Refer to REMOVAL [03/2019 - 09/2019] , or refer to REMOVAL [09/2019 - 06/2021] , or refer to REMOVAL [06/2021 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - 03/2023] , or refer to REMOVAL [03/2023 - 09/2024] , or refer to REMOVAL [09/2024 - ]

   HINT: 

   Perform "Inspection After Repair" after replacing the cam timing control motor with EDU assembly.

   Refer to INITIALIZATION [06/2018 - 09/2019] , or refer to INITIALIZATION [09/2019 - 04/2020] , or refer to INITIALIZATION [04/2020 - 11/2022] , or refer to INITIALIZATION [11/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

5. Turn the ignition switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
2. Enter the following menus: Powertrain / Engine / Trouble Codes.
3. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P2614-01 is output	B

Result: 

A 

END 

Result: 

B 

REPLACE ECM 

Refer to REMOVAL [03/2019 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - 03/2023] , or refer to REMOVAL [03/2023 - 09/2024] , or refer to REMOVAL [09/2024 - ]