LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 65 (Meter / Gauge System (HEV) - Diagnostic Codes, Symptom Tests & Circuit Tests) >> METER / GAUGE SYSTEM (for HV Model) >> Engine Oil Pressure Switch Circuit [04/2020 - 09/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
  • The following troubleshooting procedure is based on the assumption that the SFI system and hybrid control system are normal. Confirm that the SFI system and hybrid control system are not malfunctioning before performing the following procedure.

    SFI system: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [01/2019 - ]

    Hybrid control system (for Nickel Metal Hydride Battery): Refer to HOW TO PROCEED WITH TROUBLESHOOTING [01/2019 - 09/2022]

    Hybrid control system (for Lithium-ion Battery): Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2020 - 09/2022]

scientia non olet · About LEMON Manuals