Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during motor cooling cooler removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane Control System (for HV Model) | Refer to INITIALIZATION [01/2019 - 09/2022] |
| Pre-collision System (for HV Model) | |||
| Replacement of ECM | Vehicle Identification Number (VIN) or frame number registration | MIL comes on | Refer to REGISTRATION [01/2019 - ] |
| Replacement of inverter with converter assembly | Resolver learning |
|
Refer to UTILITY [01/2019 - 09/2022] |
WARNING:
- This vehicle has contains high voltage circuits standardized with orange colored wiring and connectors, so follow the instructions in appropriate service information
to perform the procedures correctly.
Refer to PRECAUTION [01/2019 - 09/2022]
- If the correct procedures are not followed according to the instructions in appropriate service information , there is a danger of electric shock from the high voltage circuits.
- Be sure to wear insulating gloves when working on high voltage wiring or components.
- If work is performed without wearing insulating gloves, there is a danger of electric shock.
NOTE:
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Audio and Visual System (for HV Model))