DTC P161A-87: Lost Communication with Alternator Missing Message [06/2018 - 03/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK CHARGING SYSTEM
- Check the charging system.
Refer to ON-VEHICLE INSPECTION [06/2018 - 09/2022]
Result
Result OK NG
Result:
NG
REPAIR OR REPLACE CHARGING SYSTEM
Result:
OK
See step 2
- Check the charging system.
- CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
- Disconnect the C76 ECM connector.
- Disconnect the C81 generator assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C76-62 (LIN) - C81-2 (LIN) Always Below 1 Ω C76-62 (LIN) or C81-2 (LIN) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE GENERATOR ASSEMBLY
for Manual Transaxle: Refer to REMOVAL [06/2018 - 01/2019] , or refer to REMOVAL [01/2019 - 03/2019]
for CVT: Refer to REMOVAL [06/2018 - 01/2019] , or refer to REMOVAL [01/2019 - 03/2019]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR