LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (Manual Transaxle System (EG60) - Service Information (1 Of 3)) >> TRANSMISSION CONTROL CABLE (except TMC Made) >> Removal [09/2022 - 11/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of ECM Vehicle Identification Number (VIN) registration MIL comes on Refer to REGISTRATION [06/2018 - ]
ECU communication ID registration (Immobiliser system) Engine start function Refer to REGISTRATION [09/2022 - 11/2022]
Gas leak from exhaust system is repaired Inspection after repair
  • Poor idle, etc.
  • Engine start function, etc.
 Refer to INITIALIZATION [04/2020 - 11/2022]
Replacement of ECM*1 Code registration (Smart Key System (for Gasoline Model, Start Function))
  • Wireless Door Lock Control System (for Gasoline Model with Smart Key System)
  • Smart Key System (for Gasoline Model, Entry Function)
  • Smart Key System (for Gasoline Model, Start Function)
  • Steering lock function*3
 Refer to REGISTRATION [09/2022 - 11/2022]
Replacement of ECM*2 Code registration (Immobiliser system)
  • Engine start
  • Telematics System
 Refer to REGISTRATION [09/2022 - 11/2022]

*1: w/ Smart Key System

*2: w/o Smart Key System

*3: w/ Steering Lock Function

WARNING:
  • When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
    GTY563662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  • Touching high-temperature areas such as the engine and exhaust pipe could result in burns.

HINT: 

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

LEARNING COMPLETES WHEN VEHICLE IS DRIVEN

Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
Pre-collision System (for TMMMS Made) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. Refer to INITIALIZATION [09/2022 - 11/2022]
Lane Tracing Assist System (for TMMMS Made)
Lane Departure Alert System (for TMMMS Made)
scientia non olet · About LEMON Manuals