Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Perform steering sensor zero point calibration	Lane Control System (for Gasoline Model)	Refer to INITIALIZATION [06/2018 - 09/2022]
		Pre-collision System (for Gasoline Model)
		Lighting System (w/ AFS) (EXT)
	Initialize back door lock*1	Power Door Lock Control System (for Hatchback, Gasoline Model)	Refer to INITIALIZATION [06/2018 - 09/2022]
Replacement of ECM	Vehicle Identification Number (VIN) registration	MIL comes on	Refer to REGISTRATION [06/2018 - ]
Replacement of ECM	ECU communication ID registration (Immobiliser system)	Engine start function	Refer to REGISTRATION [01/2019 - 09/2019] , or refer to REGISTRATION [09/2019 - 04/2020] , or refer to REGISTRATION [04/2020 - 09/2022]
Gas leak from exhaust system is repaired	Inspection after repair	Poor idle, etc. Engine start function, etc.	Refer to INITIALIZATION [06/2018 - 09/2019] , or refer to INITIALIZATION [09/2019 - 04/2020] , or refer to INITIALIZATION [04/2020 - 11/2022]
Replacement of ECM*2	Code registration (Smart Key System (for Gasoline Model, Start Function))	Wireless Door Lock Control System (for Gasoline Model with Smart Key System) Smart Key System (for Gasoline Model, Entry Function) Smart Key System (for Gasoline Model, Start Function) Steering lock function	Refer to REGISTRATION [01/2019 - 09/2019] , or refer to REGISTRATION [09/2019 - 04/2020] , or refer to REGISTRATION [04/2020 - 09/2022]
Replacement of ECM*3	Code registration (Immobiliser system)	Engine start	Refer to REGISTRATION [01/2019 - 09/2019] , or refer to REGISTRATION [09/2019 - 04/2020] , or refer to REGISTRATION [04/2020 - 09/2022]

*1: for Hatchback

*2: w/ Smart Key System

*3: w/o Smart Key System

WARNING:

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.

NOTE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System (for Gasoline Model))