Replacement [06/2018 - 01/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE FRONT DRIVE SHAFT ASSEMBLY
Refer to REMOVAL [06/2018 - 01/2019]
- REMOVE FRONT DRIVE SHAFT OIL SEAL LH
- REMOVE FRONT DRIVE SHAFT OIL SEAL RH
- INSTALL FRONT DRIVE SHAFT OIL SEAL RH
- Coat the lip of a new front drive shaft oil seal RH with MP grease.
- Using SST and a hammer, tap in the front drive shaft oil seal RH to the manual transaxle assembly.
*a Depth - SST: 09316-10010
- SST: 09950-70010
- 09951-07100
Standard Depth
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTE:Do not damage the front drive shaft oil seal RH lip.
- INSTALL FRONT DRIVE SHAFT OIL SEAL LH
- Coat the lip of a new front drive shaft oil seal LH with MP grease.
- Using SST and a hammer, tap in the front drive shaft oil seal LH to the manual transaxle assembly.
*a Depth - SST: 09649-17010
- SST: 09950-70010
- 09951-07100
Standard Depth
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTE:Do not damage the front drive shaft oil seal LH lip.
- INSTALL FRONT DRIVE SHAFT ASSEMBLY
Refer to INSTALLATION [06/2018 - 01/2019]