Inspection [06/2018 - 11/2022]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
Standard Resistance
| Tester Connection |
Switch Condition |
Specified Condition |
| 1 - 2 |
Pushed |
Below 1 Ω |
| Released |
10 kΩ or higher |
If the result is not as specified, replace the back-up light switch assembly.