Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during clutch pedal sub-assembly removal/installation are shown below.
WARNING:
Be sure to read Precaution thoroughly before servicing.
- for TMC Made Gasoline Model:
Refer to PRECAUTION [09/2022 - 11/2022]
- for TMMMS Made:
Refer to PRECAUTION [09/2022 - 11/2022]
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
| Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| Front Camera System (for TMC Made) |
|
Refer to INITIALIZATION [09/2022 - 11/2022] |
| Pre-collision System (for TMMMS Made) | Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. | Refer to INITIALIZATION [09/2022 - 11/2022] |
| Lane Tracing Assist System (for TMMMS Made) | ||
| Lane Departure Alert System (for TMMMS Made) |
*1: for GR Model
*2: except GR Model
LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY
| Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. | Refer to INITIALIZATION [09/2022 - 11/2022] |
*1: for Hatchback