Removal [11/2022 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 1 [11/2022 - 09/2024] , or refer to PROCEDURE - Step 1 [09/2024 - ]
DISCONNECT CLUTCH MASTER CYLINDER ASSEMBLY
See step 3

REMOVE CLUTCH START SWITCH ASSEMBLY

Disconnect the clutch start switch assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the nut and clutch start switch assembly from the clutch pedal support sub-assembly.

NOTE:

To prevent damage to the clutch start switch assembly, make sure not to rotate it during removal.