Removal [09/2022 - 11/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
- for G16E-GTS:
  Refer to PROCEDURE - Step 1
- except G16E-GTS:
  Refer to PROCEDURE - Step 1
DISCONNECT CLUTCH MASTER CYLINDER ASSEMBLY
See step 3

REMOVE CLUTCH START SWITCH ASSEMBLY

Disconnect the clutch start switch assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the nut and clutch start switch assembly from the clutch pedal support sub-assembly.

NOTE:

To prevent damage to the clutch start switch assembly, make sure not to rotate it during removal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE CLUTCH SWITCH ASSEMBLY (w/o Clutch Pedal Stroke Sensor Assembly)

Disconnect the clutch switch assembly connector.

Loosen the nut and remove the clutch switch assembly from the clutch pedal support sub-assembly.