Removal [06/2018 - 01/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
- DISCONNECT CLUTCH MASTER CYLINDER ASSEMBLY
See step 2
- REMOVE CLUTCH SWITCH ASSEMBLY
- Disconnect the clutch switch assembly connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the nut and clutch switch assembly from the clutch pedal support sub-assembly.
NOTE:
To prevent damage to the clutch switch assembly, make sure not to rotate it during removal.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|