Removal [01/2019 - 09/2022]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
- DISCONNECT CLUTCH MASTER CYLINDER ASSEMBLY
See step 2 [01/2019 - 03/2019], or See step 2 [03/2019 - 09/2022]
- REMOVE CLUTCH START SWITCH ASSEMBLY
- Disconnect the clutch start switch assembly connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the nut and clutch start switch assembly from the clutch pedal support sub-assembly.
NOTE:
To prevent damage to the clutch start switch assembly, make sure not to rotate it during removal.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE CLUTCH SWITCH ASSEMBLY (w/o Clutch Pedal Stroke Sensor Assembly)
- Disconnect the clutch switch assembly connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Loosen the nut and remove the clutch switch assembly from the clutch pedal support sub-assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|