Inspection [11/2022 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT CLUTCH START SWITCH ASSEMBLY
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Clutch Start Switch Assembly)*b 11.65 to 12.35 mm (0.459 to 0.486 in.) *c On *d Off Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 On (Pushed in) Below 1 Ω Off (Released) 10 kΩ or higher If the result is not as specified, replace the clutch start switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Check the resistance.