LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Corolla L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (M/T Clutch - Service Information) >> Clutch Pedal Switch >> Inspection [01/2019 - 11/2022] >> Procedure

Inspection [01/2019 - 11/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT CLUTCH START SWITCH ASSEMBLY 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY857924Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Clutch Start Switch Assembly)
        *b 11.65 to 12.35 mm (0.459 to 0.486 in.)
        *c On
        *d Off

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 On (Pushed in) Below 1 Ω
        Off (Released) 10 kΩ or higher

        If the result is not as specified, replace the clutch start switch assembly.

  2. INSPECT CLUTCH SWITCH ASSEMBLY (w/o Clutch Pedal Stroke Sensor Assembly) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY840113Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Clutch Switch Assembly)
        *b 6.5 to 7.5 mm (0.256 to 0.295 in.)
        *c On
        *d Off

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 On (Pushed in) Below 1 Ω
        Off (Released) 10 kΩ or higher

        If the result is not as specified, replace the clutch switch assembly.

scientia non olet · About LEMON Manuals